KEPCO BOP-ME 1KW, Operator'S Manual

Page: 22 / 234

1-2
BOP HIPWR 091719
1.2.1 LXI COMPATIBILITY (ME MODELS)
BOP with the ME suffix are designed to meet the LXI Version 1.4 standard, providing the follow-
ing standardized web interface capabilities for the user:
Discovery:
- MDNS (Bonjour - like the printer discovery)
- VXI-11 (National Instruments Ni Max, Agilent Io controller)
IP address support:
- DHCP
- AUTOIP
- Static IP (using Web Page)
Connections:
- SOCKET @ port 5025
- TELNET @ port 5024
Connection throughput:
- 25 milliseconds
NOTE: VXI-11 socket connection is provided for discovery. It only supports the *idn? query in
operation. Consult factory if this slow connection is required.
1.3 SPECIFICATIONS
Table 1-1 below indicates parameters that vary for different 1000 Watt BOP models; Table 1-2
lists general specifications that apply to all 1000 Watt BOP models.
TABLE 1-1. BOP 1000 WATT MODEL PARAMETERS
Model
d-c Output Range Closed Loop Gain Output Impedance
Voltage
(V d-c)
Current
(A d-c)
Voltage
Channel
G
V
(V/V)
Current
Channel
G
I
(A/V)
Voltage Mode
(Series R - L)
Current Mode
(Parallel R - C)
R
d-c
(mOhms)
L
(

H)
R
d-c
(Ohms)
C
(

F)
1000 WATT MODELS
BOP 6-125MG/ME 0 to ±6 0 to ±125 0.6 12.5 0.05 1.5 24 1150
BOP 10-100MG/ME 0 to ±10 0 to ±100 1.0 10.0 0.1 2.0 50 1100
BOP 10-75MG/ME 0 to ±10 0 to ±75 1.0 7.5 0.13 2.0 67 976
BOP 20-50MG/ME 0 to ±20 0 to ±50 2.0 5.0 0.40 8.3 200 371
BOP 25-40MG/ME 0 to ±25 0 to ±40 2.5 4.0 0.63 15.8 313 165
BOP 36-28MG/ME 0 to ±36 0 to ±28 3.6 2.8 1.30 25 640 103
BOP 50-20MG/ME 0 to ±50 0 to ±20 5.0 2.0 2.50 50 1250 55
BOP 72-14MG/ME 0 to ±72 0 to ±14 7.2 1.4 5.14 104 2570 33
BOP 100-10MG/ME 0 to ±100 0 to ±10 10.0 1.0 10.0 163 5000 16
NOTE: When connecting active loads, the steady-state voltage of the active load must not exceed the maximum voltage rating of the
BOP. Otherwise the overvoltage protection will shut down the power supply.