KEPCO BOP-ME 1KW, Operator'S Manual

Page: 23 / 234

BOP HIPWR 091719
1-3
TABLE 1-2. BOP GENERAL SPECIFICATIONS
SPECIFICATION RATING/DESCRIPTION CONDITION
INPUT CHARACTERISTICS
a-c voltage nominal 200/220/230/240Va-c
(1)
(200-240 Va-c)
No setting required. Single phase or between
2 phases of a 3-phase system within 200-
240Va-c.
range 176 - 264 Va-c Continuous; Input voltage outside range
causes protection fault.
Frequency nominal 50/60 Hz
range 47 - 63 Hz
Current 176 Va-c 9.5A (7.5A
(2)
) maximum
264 Va-c 6.4A (4.4A
(2)
) maximum
Power factor Source 0.99 minimum
nominal output power
Sink 0.97 minimum
Efficiency 65% (56%
(2)
) minimum when sourcing
Switching frequency, front end module 70 KHz ±5% (50KHz ±5%
(2)
) Active PFC Input for both Source and Recu-
peration (Sink)
EMC Compliance EN61326-1 (1997) Class A equipment
EMC immunity to: ESD EN61000-4-2 Electrostatic discharge
Radiated RF EN61000-4-3
EFT EN61000-4-4 Electrical fast transient/burst
Surges EN61000-4-5
Conducted RF EN61000-4-6
EMC emissions Conducted EN61000-3-2 harmonics
EN61000-3-3 fluctuation & flicker
Conducted EN55011/CISPR11 0.15 to 30 MHz
Radiated EN55011/CISPR11 30 to 1000 MHz
Leakage current 3.5 mA 230V a-c, 47-63 Hz
Insulation coordination Input Installation Category II For TN or TT power system
Overvoltage Category II
Output Installation Category II Maximum 300V (500V for BOP 10-100MG/
ME) common mode voltage between output
terminals and chassis ground.
Overvoltage Category II
Pollution degree 2
OUTPUT CHARACTERISTICS
(3)
Type of stabilizer Voltage-current, 4-quadrant Switch mode
Switching frequency, output module 100KHz ±5% Output Stage
Source adjustment
range voltage -100% to +100% of rating 0 to 50 deg C
current -100% to +100% of rating
Sink adjustment range voltage -100% to +100% of rating 0 to 50°C, recuperated energy is sent
back into line for general reuse
current -100% to +100% of rating
(1) All specifications listed in this table are for 230V a-c input voltage.
(2) BOP 6-125MG/ME and BOP 10-75MG/ME only.
(3) Output characteristics are for a single standalone unit. Output characteristics of identical multiple unit parallel/series configurations
are described in the Technical Manual associated with the applicable Cable Kit (see Table 1-4).