4
EN
Operation
When the
STANDBY
indicator is lit, the power turns ON when you press
the
POWER RCVR
key on the remote control. When the power comes
ON, press the key you want to operate.
• When pressing more than one remote control key successively, press the
keys securely by leaving an interval of 1 second or more between keys.
Notes
1. The supplied batteries may have shorter lives than ordinary batteries
due to use during operation checks.
2. When the remote-controllable distance gets shorter than before,
replace both batteries with new ones.
3. Placing the remote sensor in direct sunlight, or in direct light from a
high frequency fluorescent lamp may cause a malfunction.
In such a case, change the location of the system installation to
prevent malfunction.
Before applying the power
FCC WARNING
This equipment may generate or use radio frequency energy.
Changes or modifications to this equipment may cause harmful
interference unless the modifications are expressly approved in
the instruction manual. The user could lose the authority to
operate this equipment if an unauthorized change or modification
is made.
NOTE:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
may cause harmful interference to radio communications, if it is not
installed and used in accordance with the instructions. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
– – Reorient or relocate the receiving antenna.
– – Increase the separation between the equipment and receiver.
– – Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
– – Consult the dealer or an experienced radio / TV technician for
help.
For the U.S.A.
Note to CATV system installer
This reminder is provided to call the CATV system installer's
attention to Article 820-40 of the NEC that provides guidelines for
proper grounding and, in particular, specifies that the cable ground
shall be connected to the grounding system of the building, as
close to the point of cable entry as practical.
Loading the batteries
1
Remove the cover.
2
Insert the batteries.
3
Close the cover.
• Insert two AA-size (R6) batteries as indicated by the polarity
markings.
Preparing the remote control
For the U.S.A.
Operating range
(Approx.)
Remote sensor
Infrared ray system
POWER RCVR
6 m
As an
E
NERGY
S
TAR® Partner, Kenwood
Corporation has determined that this
product meets the
E
NERGY
S
TAR®
guidelines for energy efficiency. This
product can save energy. Saving energy
reduces air pollution and lowers utility bills.
*5470/01-09/EN
04.6.10, 5:38 PM
4
