key
dust bag full Indicator
on/off button
carry handle
speed control function (some
models only)
cord rewind button
wheel
air release valve
flexible hose
extension tubes
crevice tool
dusting brush
floor brush
dust bag
filters
rear filter cover
to use the vacuum
cleaner
1 Fit the flexible hose into the vacuum
cleaner: press the button firmly and
at the same time push the hose into
the appliance until it clicks into
position
.
●
To remove, first unplug the appliance
from the power supply then press
the button and remove the hose.
2 Unwind sufficient length of cord and
connect to the power supply. A
yellow mark on the cord indicates the
ideal length, don’t extend the cord
beyond the red mark.
●
To rewind the cord, press the cord
rewind button with one hand and
guide the cord into the appliance
with the other hand. Failure to do
this may cause damage.
3 To use the extension tubes, place one
inside the other. If it doesn’t fit, retry
using the other end of
one
tube. Fit
the extension tube to the flexible hose,
again if it doesn’t fit, retry using the
other end of
one
tube.
4 Select the required tool and push on
the end of the tube.
floor brush, crevice tool and
dusting brush
●
The floor brush can be used on
carpets and hard floors. Select the
required position by pressing one of
the levers on the top of the floor
brush
.
●
Use the crevice tool to clean in
narrow spaces such as behind
radiators, in crevices and corners.
●
Use the dusting brush to clean
furniture, blinds, lamp shades,
shelves etc.
5 Check that the air release valve is
closed, then switch on by pressing
the on/off button. Ensure that the
area you are vacuuming is well lit.
●
The air release valve on the hose
handle allows you to adjust the
airflow or to release anything
attached to the nozzle.
6 Switch off after use.
3
