PACKET-2
DATA BAND
Select how data will be transmitted and received on your
transceiver.
1
Enter Menu mode and access Menu 930.
2 Set the data band to A-BAND (A band receives and
transmits), B-BAND (B band receives and transmits), TX:A-
BAND RX:B-BAND (A band transmits (
) and B band
receives (
)), or RX:A-BAND TX:B-BAND (A band receives
(
) and B band transmits (
)).
COM PORT SPEED
You can adjust the speed at which the computer and transceiver
exchange information, when the transceiver is connected to your
computer.
1
Enter Menu mode and access Menu 929.
2
Set the COM port speed to 9600, 19200, 38400, or 57600
bps.
•
Turning the power ON/OFF will change the port speed setting.
USING EXTERNAL TNC
■
External Data Band
1
Enter Menu mode and access Menu 918.
2 Set the data band to A-BAND (A band receives and
transmits), B-BAND (B band receives and transmits),
TX:A-BAND RX:B-BAND (A band transmits and B band
receives), or RX:A-BAND TX:B-BAND (A band receives
and B band transmits).
■
DATA Terminal Speed
Select 1200 or 9600 bps for the data transfer rate, depending
on TNC.
1200
bps:
Transmit data input (PKD) sensitivity is 40 mV
p-p
,
and input impedance is 10 k
.
9600
bps:
Transmit data input (PKD) sensitivity is 2 V
p-p
, and
input impedance is 10 k
.
1
Enter Menu mode and access Menu 919.
2
Set the data speed to 1200 or 9600 bps.
■
SQC Output Setting
You can set the condition for which the SQC output terminal
becomes active.
1
Enter Menu mode and access Menu 921.
2
Set the SQC output activation method to one of the
following:
•
OFF: SQC output remains inactive.
•
BUSY: When a signal is received on the data band, the SQC
output becomes active.
•
SQL: While CTCSS/DCS is ON and a matching signal is
received, the SQC output becomes active. While CTCSS/
DCS is OFF, the SQC output becomes active when a busy
signal is received.
•
TX: While transmitting, the SQC output becomes active.
•
BUSY.TX: When the conditions of BUSY and TX (above) are
met, the SQC output becomes active.
•
SQL.TX: When the conditions of SQL and TX (above) are
met, the SQC output becomes active.
Note:
The activation type (logic) can be changed using the MCP-6A
software ([Edit] - [Data Terminal] - [SQC Output Logic]).
