VGS-3
■
Continuous Recording
Received signals on the control band are continuously
recorded, with the memory retaining the last 30 seconds of
recorded signals.
1 Enter Menu mode and access Menu 009.
2 Set the Continuous Recording to ON (or OFF).
•
When selecting “ON”, Continuous Recording turns ON. When
the control band squelch opens, the
icon appears on the
display and Received signals are recorded.
•
Received signals are saved in the SRAM memory.
3 Press the PF key programmed as [VGS].
4 Press [4] (1s).
•
Up to 30 seconds of received signal recordings from the
SRAM memory are written to channel 4.
Note: The
icon does not appear during playback, in Repeater mode, or
in Remote Control mode.
■
Playback
1 Press the PF key programmed as [VGS].
•
When preparing to transmit, press the [PTT] switch before
pressing the channel number (1 - 3) key.
2 Press the key for the VGS channel number you want
to playback: [1], [2], [3], or [4] (when the Continuous
Recording is ON).
•
The recording saved in the channel you selected is played
back.
•
To end playback at any time, press [CLR].
•
Playback signals are output from the PTT band side. Use the
[BAND SEL (VOL)] of the PTT band to adjust the speaker
volume.
•
To exit, press [VGS] again.
•
During playback, you can switch to any of recordings 1, 2, 3,
or 4 by pressing the appropriate key.
■
Playback Repeat
You can set messages to be repeatedly played back.
1 Enter Menu mode and access Menu 007.
2 Set the Playback Repeat function to ON or OFF.
■
Playback Repeat Interval
If the Playback Repeat function is activated, you can set a
time interval for how often the memo/message is played back.
1 Enter Menu mode and access Menu 008.
2 Set the interval from 0 to 60 seconds.
