45
PROGRAMMING A TONE FREQUENCY
You must also program the CTCSS tone to operate the
Sky Command II+. Select the same CTCSS tone for
both the Commander and the Transporter.
1 Press [F1] (1 s) until you select group A.
2 Press [F1] until you select A–3.
3 Press [MENU].
4 Turn the MULTI/ CH control to select Menu No. 62.
5 Press [SUB].
6 Turn the MULTI/ CH control to select Menu No. 62C.
7 Press [–]/ [+] to select a CTCSS tone frequency for
the Sky Command II+ operation.
8 Press [OK] to store the CTCSS tone frequency for
the Sky Command II+ operation. Press [CLR] to
cancel the selection.
PROGRAMMING COMMUNICATION SPEED
You must configure the same TNC communication speed
between the Commander and the Transporter.
1 Press [F1] (1 s) until you select group A.
2 Press [F1] until you select A–3.
3 Press [MENU].
4 Turn the MULTI/ CH control to select Menu No. 62.
5 Press [SUB].
6 Turn the MULTI/ CH control to select Menu No. 62D.
7 Press [–]/ [+] to select either 1200 bps or 9600 bps.
8 Press [OK] to store the TNC communication speed
for the Sky Command II+ operation. Press [CLR] to
cancel the selection.
Note: 9600 bps can be used only when you use TS-2000(X)/ TS-B2000
for both the Commander and the Transporter.
CONFIGURING A TNC BAND
If you are using a TS-2000(X)/ TS-B2000, confirm that
the built-in TNC is assigned to the sub-receiver.
1 Press [F1] (1 s) until you select group A.
2 Press [F1] until you select A–3.
3 Press [MENU].
4 Turn the MULTI/ CH control to select Menu No. 46.
5 Press [–]/ [+] to select “SUB”.
6 Press [OK] to store the TNC band for the Sky
Command II+ operation. Press [CLR] to cancel the
selection.
Summary of Contents for TM-942A
Page 60: ......
