TK-380
8
OPERATING FEATURES
2-4. Display
3. Scan Operating
1) Scan types
●
Single Group Scan
You can scan all valid (ADD) channels in the displayed group
that can be selected with the group selector.
●
Multiple Group Scan
You can scan all valid (ADD) channels in the all valid (ADD)
group.
2) Scan Start Condition
One or more non-priority channels must be added to all
channels that can be scanned. The transceiver must be in
normal receive mode (PTT off).
When you activate the key programmed to the scan function,
the scan starts. The scan icon “SCN” lights and “-SCAN-” or
revert channel (programmable) is indicated on alphanumeric
display.
3) Scan Stop Condition
The scan stops temporarily if the following conditions are
satisfied.
1
A carrier is detected, then signalling matches on channels
for which receive the signalling is set by the programming
software.
2
A carrier is detected on the channel for which receiving
signalling is not set by the programming software or when
the monitor (signalling cancel) function is activated.
4) Scan Channel Types
1
Priority channel is the most important channel for the scan,
and always detects a signal during scan and when the scan
stops temporarily.
2
Non-priority channels detects a signal during scan. For the
channels that can be selected with the group or channel
selector when the scan does not occur, adds an indicator
(
∞
) lights.
5) Priority Channel Setting
A priority channel can be set as follows with the programming
software (KPG-60D).
1
Specify a priority channel as a fixed priority channel.
2
Make a selected channel a priority channel.
6) Scan Type According to the Priority Channel
1
When no priority channel is set : Only the non-priority
channels are scanned.
If a non-priority channel stops temporarily, it stops until
there is no signal on the channel.
2
When priority channel is set : Either priority channel is
scanned.
If a non-priority channel stops temporarily, a priority channel
signal is detected at certain intervals.
If a priority channel stops temporarily, it stops until there is
no signal on the priority channel.
P
9
1
Sub display
Displays the system, channel and group numbers. Also
displays various functions, such as TA.
2
P (Priority) indicator
The P indicator (
P
) appears when a selected channel is
programmed as priority.
3
MON (Monitor) indicator
The MON indicator appears when the button programmed
as MONITOR is pressed.
4
SVC (Service) indicator
This icon is not used on this transceiver.
5
SCN (Scan) indicator
The SCN indicator appears when using Scan mode.
6
LO indicator
Appears when low power is selected.
7
Handset indicator
This icon is not used on this transceiver.
8
MAIL indicator
Flashes when a status message (5tone or DMS) is received.
Lights when a status message is stored in the stack memory.
9
Alphanumeric display
The twelve-character dot matrix alphanumeric display
shows the group and channel numbers. You can program
group and channel names with up to ten characters in place
of these numbers. The left display is used as an add
indicator (
∞
) and the right is used for the selective call (:+:)
or scrambler ( _ ) function. The add indicator shows the
channels unlocked out of the scanning sequence. Selective
call and scrambler are optional functions that can be
programmed.
Summary of Contents for TK-380
Page 33: ...TK 380 33 PARTS LIST ...
