TK-373G
9
REALIGNMENT
8. If you want to continue programming other TK-373Gs,
repeat steps 4 to 7.
Notes:
●
This mode cannot be entered if the Firmware Programming
mode is set to Disable in the Programming software (KPG-
76D).
●
When programming the firmware, it is recommend to copy
the data from the floppy disk to your hard disk before you
update the radio firmware.
Directly copying from the floppy disk to the radio may not
work because the access speed is too slow.
6-4. Function
1. If you press the [Side2] switch while "PROG XXX" is
displayed, the checksum is displayed. If you press the
[Side2] switch again (while the checksum is displayed),
"PROG XXX" is redisplayed.
2. A transmission speed can be selected by pressing the [Side1]
switch while "PROG XXX" is displayed.
19200 bps: The LED flashes green and red alternately.
38400 bps: The LED flashes orange.
57600 bps: The LED lights orange.
Note:
Normally, write in the high-speed mode.
7. Clone Mode
Programming data can be transferred from one radio to
another by connecting them via their SP/MIC connectors. The
operation is as follows (the transmit radio is the master and
the receive radio is the slave).
1. Turn the master TK-373G power ON with the [Side1]+[
5
]
key held down. The TK-373G displays "
CLONE ".
2. Power on the slave TK-373G.
3. Connect the cloning cable to the SP/MIC connectors on
the master and slave.
4. Press the [A] key on the master while the master displays
"
CLONE ". The data of the master is sent to the slave.
While the slave is receiving the data, "-PC-" is displayed. When
cloning of data is completed, the master displays "END", and
the slave automatically operates in the User mode. The slave
can then be operated by the same program as the master.
5. The other slave can be continuously cloned. When the [A]
key on the master is pressed while the master displays
"END", the master displays "
CLONE ". Carry out the
operation in steps 2 to 4.
Note: You can clone the programmed data between the
transceiver frequency version must be same.
Use the new clonig cable for TK-372G/373G.
You cannot use the old cloning cable for TK-360/370.
Cloning cable parts No.
E30-3410-05 (TK-373G
→
TK-373G)
φ
3.5
φ
2.5
φ
3.5
φ
2.5
GND
REMOTE/TXD
PTT/RXD
Cloning cable
Fig. 2
