TK-373G
7
OPERATING FEATURES / REALIGNMENT
REALIGNMENT
1. Modes
User mode
Panel test mode
PC mode
Firmware
programming mode
Clone mode
Panel tuning mode
PC test mode
Data programming
mode
PC tuning mode
Checksum
3. For the panel Test Mode
For the setting method, refer to ADJUSTMENT.
3-1. For the panel Tuning Mode
For the setting method, refer to ADJUSTMENT.
• Alert tone
This tone is output when the transceiver is in TX inhibition
for TOT, battery warning and PLL unlocked. It is output until
the PTT button is released. (The 697Hz tone is output.)
• Busy Tone
In trunked mode the busy tone informs the user when the
repeater cannot be used (System busy or TX inhibit Status).
• Intercept tone
This tone indicates that the transceiver is out of range. It
indicates that the PTT button is pressed, and transmission has
started, but the repeater cannot be connected and talking is
not possible. It is output until the PTT button is released. (The
mid tone and low tone are output alternately in 200ms intervals.)
• Delay tone
This tone is output when the PTT button is pressed and the
repeater is accessed three times or more to indicate connection
with the repeater is delayed. This tone is the same as the busy
tone. (It is not output of CLEAT TO TALK has been set to
YES.)
• Proceed tone
This tone is output when the PTT button is pressed,
transmission starts, and the repeater is connected to indicate
that the user can talk if the Clear-to-talk function has been set.
(The high tone is output for 100ms.)
• Free system ringback mode tone, system search mode
tone
This tone indicates that the transceiver is free system
ringback mode or system search mode. (The low tone is output
for 400ms.)
• Ringing tone
This tone indicates that the transceiver can use the repeater
in free system ringback mode. (The mid tone and no tone are
output eight cycles alternately in 50ms intervals.)
Mode
Function
User mode
For normal use.
Panel test mode
Used by the dealer to check the
fundamental characteristics.
Panel tuning mode
Used by the dealer to tune the radio.
PC mode
Used for communication between the
radio and PC (IBM compatible).
Data programming
Used to read and write frequency data
mode
and other features to and from the radio.
PC test mode
Used to check the radio using the PC.
This feature is included in the FPU.
See panel tuning.
Firmware program-
Used when changing the main
ming mode
program of the flash memory.
Clone mode
Used to transfer programming data
from one radio to another.
2. How to Enter Each Mode
Mode
Operation
User mode
Power ON
Panel test mode
[
∞
]+Power ON (Two seconds)
PC mode
Received commands from PC
Panel tuning mode
[Panel test mode]+[A]
Firmware programming mode [Side1]+[Side2]+Power ON
(Two seconds)
Clone mode
[Side1]+[
5
]+Power ON
(Two seconds)
