Kenwood TK-2402, Service Manual

Page: 7 / 46

TK-2402(V)/2402/2406/2407
7
5. Attaching the Battery Release Lever to
the Case Assembly
1. Insert one side of the shaft into the hole at the lever fi tting
section on the case assembly
a
.
Caution: The thin spring (G01-4543-14) should be posi-
tioned above the two tabs of the lever.
2. Tilt the battery release lever slightly forward b , so that
the thick spring (G01-4542-04) is positioned below the
case surface.
3. With the thick spring positioned below the case surface,
attach the other side of the shaft to the case assembly
by pressing the battery release lever
c
until it snaps into
place d .
Caution: Be careful not to tilt the battery release lever
too forward.
If the battery release lever is pushed in this state where
the two tabs come below the case surface, there is a
possibility of damaging the two tabs.
A thin spring
Shaft
Tow tabs
A thick spring
a
b
d
c
6. Assembling the Battery Release Lever
1. Place the lever b onto the stopper a .
2. Place the thick spring
c
onto the lever.
3. Hook the right and left ends of the thin spring d onto the
tabs of the stopper, then place the thin spring onto the
lever
e .
4. Slide the shaft through the hole of the stopper and lever
f
.
a
b
c
d
e
f
7. Attaching the Positive Terminal to the
Chassis
Always attach the positive terminal to the chassis, using
the following procedures, before mounting the TX-RX unit
onto the chassis.
1. Remove the holder assembly
b
from the packing
a
of
the positive terminal.
2. Mount the packing of the positive terminal into the chas-
sis hole c .
3. Mount the holder assembly into the packing of the posi-
tive terminal d .
a
c
b
d