TK-2217
18
DISASSEMBLY FOR REPAIR /
维修拆卸
4
5
3
1
6
2
1
3
2
4
A thin spring /
细弹簧
Shaft /
轴
Two tabs /
2个突起的上侧
A thick spring /
粗弹簧
Precautions for Reassembly
■
Attaching the battery release lever to the case
assembly
1. Insert one side of the shaft into the hole at the lever fitting
section on the case assembly
z
.
Note:
The thin spring (G01-4543-04) should be positioned
above two tabs of the lever.
2. Tilt the battery release lever slightly forward
x
, so that the
thick spring (G01-4542-04) is positioned below the case
surface.
3. With the thick spring positioned below the case surface, attach
the other side of the shaft to the case assembly by pressing
the battery release lever
c
until it snaps into place
v
.
Note:
Be careful not to tilt the battery release lever too
forward.
If the battery release lever is pushed in this state where
two tabs come below the case surface, there is a
possibility of damaging two tabs.
■
Assembling the battery release lever
1. Place the lever
x
onto the stopper
z
.
2. Place the thick spring
c
onto the lever.
3. Hook the right and left ends of the thin spring
v
onto the tabs
of the stopper, then place the thin spring onto the lever
b
.
4. Slide the shaft through the hole of the stopper and lever
n
.
重新组装注意事项
■
安装电池分离拨杆到机壳
1. 把轴的一侧插入到机壳的拨杆安装部的孔里。
z
注∶
细弹簧(G01-4543-04)必须安装到拨杆的 2 个突起上面。
2. 轻轻地前推电池分离拨杆倾斜倒
x
，这样粗弹簧(G01-4542-
04)就被定位在机壳下面。
3. 粗弹簧被定位到机壳下面之后，通过按电池分离拨杆
c
直
到它嵌入位置
v
，轴的另一侧接触机壳组件。
注∶
注意不要把电池分离拨杆倾斜得太靠前。
如果电池分离拨杆被推到分离拨杆下面的2个卡头的位置，
就有可能损坏这 2 个卡头。
■
电池分离拨杆的组装方法
1. 请把拨杆
x
置于止动器
z
的上面。
2. 请把粗弹簧
c
置于拨杆的上面。
3. 请把细弹簧置于拨杆上面，并让细弹簧
v
的左右端置于止
动器的两个卡头内。
b
4. 滑动轴穿过止动器和拨杆的孔。
n
