Kenwood STZ-RF200WD, Instruction Manual

Page: 20 / 80

20
Troubleshooting
Issue Cause / Solution
The indicator does not light
up even though the vehicle
ACC is ON.
y
Is the fuse blown?
3
Address the cause of the blown fuse and replace the fuse.
(Always use fuses of the specified capacity)
y
Is the in-line connector for the power cable or switch cable
disconnected?
3
Check the connections of the in-line connectors.
The orange status LED is
blinking. (see p. 16 )
y
Press the switch and the status LEDs will inform you of the error
details.
The display indicates an SD
card error. (see p. 16 )
y
Is the SD card inserted correctly?
3
If there is no change after the SD card is inserted correctly, format
the SD card or replace it with a new one.
The display indicates a front
camera error. (see p. 16 )
y
Is the in-line connector for the front camera disconnected?
3
Check the connections of the in-line connectors. (see p. 14 )
The display indicates a rear
camera error. (see p. 16 )
y
Is the in-line connector for the rear camera disconnected?
3
Check the connections of the in-line connectors. (see p. 14 )
The display indicates
that the camera is not
connected while adjusting
the recording angle.
(see p. 16 )
y
Is the in-line connector for the camera cable disconnected?
3
Check the connections of the in-line connectors. (see p. 14 )
The display indicates a GPS
error. (see p. 16 )
y
Is the in-line connector for the GPS device disconnected?
3
Check the connections of the in-line connectors. (see p. 14 )
The display indicates that
the temperature is high.
(see p. 16 )
y
The unit is hot. Turn off image stabilization and temporarily reduce the
frame rate to prevent heat from generating and continue recording.
Stop recording if the temperature does not drop.
The display indicates a
switch error. (see p. 16 )
y
Is the in-line connector for the switch disconnected?
3
Check the connections of the in-line connectors. (see p. 14 )
The camera and main unit
will generate heat during
use.
y
Is it too hot to touch?
3
It will heat up during use. Stop use immediately if it is too hot to
touch and contact the office listed in this manual.
The time displayed on
recorded video is incorrect.
y
Is the top of the GPS antenna covered by metal or something with a
metal coating?
3
Remove the item covering it. Or move the GPS antenna to a
location where nothing will cover it. If the issue is not resolved, use
a dedicated cell phone app to synchronize the time.