13
• GPS antenna
Install the GPS device in a location where it can easily receive satellite signals, such as near the handle-
bars or on top of the gas tank. Remove the release paper from the double-sided tape before installing.
• Switch
Install the switch in a location that is easy to operate and will not interfere with safe operation of the
motorcycle, such as on or nearby the left handlebar.
Remove the release paper from the double-sided tape before installing.
• Front and rear cameras
Install the cameras in locations where the field of view will not be affected by the motorsports vehicle
itself.
Remove the protective film from the double-sided tape before installing. Use screws, nuts (not includ
-
ed), and cable ties as needed to secure the cameras in place.
After installation, use the KENWOOD Motorsports CAM App to check the video feed and adjust the
camera. See
p. 18 “Adjusting the field of view” for more details.
•
When using double-sided tape to install the unit, remove dirt and fingerprints from the installation
location using a commercial cleaning cloth and wait for the location to dry before proceeding. Re-
using tape or using general purpose double-sided tape for installation will provide less adhesive
power and presents a risk of the unit falling off.
• Use cable ties to secure cables so that they do not droop. Improper wiring or securing could
result in wires falling, malfunctions, fires, or accidents.
Summary of Contents for STZ-RF200WD
