0
i
ncoming
c
All
n
otificAtion
t
ype
Note:
To use Incoming Call Notification, you must set up a QT tone
or a DQT code {page 16}.
Incoming Call Notification is used to inform you of when a call
is being received. When activated, a tone is emitted when a
busy signal is received and the QT/ DQT signalling matches.
• The tone will sound for 15 seconds before turning off.
• While the tone sounds, you will not hear any audio from the
speaker. Press any key to turn the tone off and listen to the
received call.
After the call is finished, the transceiver will wait for 10 seconds
before resetting. If you receive a new call within those 10
seconds, the tone will not sound. If no call is received within
10 seconds, Incoming Call Notification will reset so that the
next time a call is received, the tone will sound again.
To turn Incoming Call Notification on or off:
With the transceiver power OFF, press and hold the
MENU
key while turning the transceiver power ON (for 1 second).
Press the
or
key to select “Ct”.
Press the
MENU
key then press
or
to select “Ct-oF”
(incoming call notification off), or “Ct-on” (incoming call
notification on).
Press the
MENU
key to confirm the selection.
Press the
PTT
,
MON
, or
CAL
key to exit Setting Mode.
