TK-3201
4
DISASSEMBLY FOR REPAIR
■
Removing the case assembly from the chassis.
1. Remove the volume knob
z
and channel knob
x
.
2. Remove the two screws
c
.
3. Lift and remove the chassis from the case assembly
v
.
(Use a flat-blade screwdriver to easily lift the chassis.)
■
Removing the TX-RX unit from the chassis.
1. Remove the packing
b
from the SP / MIC jack of the TX-
RX unit.
2. Remove the eleven screws
n
fixing the TX-RX unit.
3. Remove the fixing bracket
m
of the SP / MIC.
4. Remove the solder of the antenna terminal with a soldering
iron
,
.
5. Remove the solder of the positive terminal with a soldering
iron
.
.
Note:
You can remove the TX-RX unit from the chassis without
removing the solder at the positive terminal. However,
in this case, you can not attach the packing (G53-1605-
03) that is on the positive terminal to the chassis in
assembling. So, it is advisable to remove the solder on
the positive terminal first.
6. Remove the FPC from the flat cable connector
/
.
7. Lift and remove the TX-RX unit from the chassis
Ω
.
1
3
3
4
2
9
6
6
6
6
6
11
5
6
6
6
7
10
8
■
Removing the battery release lever from the case
assembly.
1. Press the upper part of the lever toward the inside of the
case assembly. One side of the shaft will be removed
z
.
2. Lift and remove the battery release lever from the case
assembly
x
.
■
Attaching the battery release lever to the case
assembly.
1. Insert one side of the shaft into the hole at the lever fitting
section on the case assembly
z
.
Caution :
The thin spring (G01-4543-04) should be positioned
above the two tabs of the lever.
2. Tilt the battery release lever slightly forward
x
, so that the
thick spring (G01-4542-04) is positioned below the case
surface.
3. With the thick spring positioned below the case surface,
attach the other side of the shaft to the case assembly by
pressing the battery release lever
c
until it snaps into place
v
.
Caution :
Be careful not to tilt the battery release lever too
forward.
If the battery release lever is pushed in this state
where the two tabs come below the case surface,
there is a possibility of damaging the two tabs.
2
1
1
3
2
4
A thin spring
Shaft
Two tabs
A thick spring
