29
•
Three tones sound after holding the
PF-2 key, confirming that the
function has been stored to the
PF-2 hold operation.
•
The press operation of the
PF-2 key cannot be reprogrammed.
Attempting to do so causes an error tone to sound.
5 Repeat steps 2 and 3 to reprogram additional functions.
6 Hold the PTT switch for 3 seconds to save the settings and exit
Setting mode.
Note: The transceiver will automatically return to normal operation if
no action is performed for 20 seconds.
PRoGRaMMaBLE FunCTIonS
n
None
No function is programmed for the key.
n
Low Transmit Power
Press or hold this key to toggle the transmit power between high
and low.
Note: FRS dedicated channel (Table no. 8 ~ 14) are fixed as low
power. If you press the Low Transmit Power key at these channel
(Example table 8), it will remain as low power and sound error tone.
n
Monitor
Press this key to deactivate QT or DQT signaling. Press the key
again to return to normal operation.
n
Scan
Press this key to turn the Scan function on and off.
Scan is useful for monitoring signals on the transceiver
channels. When scanning, the transceiver checks for a signal on
each channel and only stops if a signal is present.
If the QT/DQT matches, the transceiver stops at the channel
and opens the squelch so you can listen to the call. If the
QT/DQT does not match, the call is ignored and scanning
continues.
n
Squelch Off
Press this key to hear background noise. Press the key again to
return to normal operation.
