Kenwood LZH-70W - LCD Monitor - External, Installation Manual, Page: 5 / 44

9. Attach the optional trim ring (model #SK-70TR) to the
console.
10. Using the marks on the roof as a guide, test-fit the con-
sole in its mounting location on the bracket assembly:
a) Open the LCD screen to expose the console’s mounting
holes.
b) Using the marks on the roof as a guide, hold the
console against the mounting bracket in the mounting
location.
c) Mark the console’s mounting screw hole locations on
the bracket and drill pilot holes.
d) Make sure screws are the correct length to avoid
damaging the vehicle roof.
11. Wire all A/V input harnesses, A/V output harnesses,
the Parental Interrupt/Mute button, IR sensors and
power harness connections to the vehicle.
• Route their multipin connectors to the console
mounting location.
• Power harness wiring: Red = Sw12 V Accessory;
Yellow = Co12 V; Black = Earth
• Mount the Parental Interrupt/Mute button in a location
easily accessible to the front-seat passengers.
12. Route all wiring harnesses through the vehicle and
through the access hole in the headliner.
• Route the wiring so there is no excess at the console
mounting location or above the headliner.
13. Re-attach the headliner.
• Start from the centre of the roof and work out towards the
sides, front, and rear.
• Ensure that all headliner attachment points are aligned.
• Re-install the visors and other hardware removed in
Step 5.
14. Make all pigtail harness connections to the console.
15. Connect the vehicle’s dome lamp wires to the
LZH-70W Dome Light Wiring Harness:
With all of the vehicle doors closed and the lights off, place
the probes of a volt meter on the vehicle’s dome light wires:
a) If the meter shows 0 V, the vehicle has a Positive
Switched system. Connect the LZH-70W’s Dome Light
Wiring Harness in the following way:
• Blue wire --> vehicle’s switched dome light wire
• Orange wire --> fused constant 12 V source
• Green wire --> a good earth point on the vehicle
LZH-70W Installation Instructions
5
Step 9: Attaching the trim ring to the console
Step 10: Test-fitting the console on the bracket
Step 14: Connecting the pigtails to the console
Eng-LZH-70WInstallManual_01.qxd 04.5.28 2:06 PM Page 5