English
|
9
Installation
Installation for Monitor Unit
Installation location and cleaning
Select for installation a location where the stand
can be placed completely horizontal or where the
front edge of the support (petal-shaped part) can
be attached horizontally as shown in Figure
A
.
Do not install in locations where the entire support
is at a diagonal such as in Figure
B
or where the
monitor unit is facing down such as in Figure
C
.
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
A
B
C
¤
• Thoroughly wipe away and dust or grease from the
installation location using a cloth which has been soaked
in a neutral cleaning agent and wrung out. Attach the
stand after allowing the installation location to dry.
Installation for Monitor Unit
1
Install the shoe on the rear of the TV monitor
temporarily using the supplied hexagon wrench
(Accessary
4
).
⁄
• When adjusting the fixing screw of the shoe, use the
hexagon wrench (Accessary
4
) that came with the
product. Using other hexagon wrenches may damage
the screw.
2
Bend the stand support to conform to the shape
of the installation location.
3
Adjust the shape of the support so that there is
no rattling or gap when the stand is placed on
the support.
4
Peel off the protective strip from the double-
sided tape on the bottom of the stand and
securely attach the stand.
¤
• Do not attach the double-sided tape more than once or
touch the adhesive with your fingers as this will weaken
its adhesive strength.
• If the temperature of the surface of the installation
location is low, warm it up using a heater or other means
before attaching the stand. Low temperature may
weaken the adhesive strength of the tape.
• The supplied stand is specially intended for this product.
Do not use it with another monitor.
5
Secure the stand using the supplied tapping
screw (Accessory
3
).
6
After attaching the stand, allow it to sit
undisturbed for 24 hours. Take care not to apply
any force to the stand during this time.
7
Insert the shoe of the monitor unit into the
bracket (Accessory
2
).
¤
• Insert the shoe into the bracket (Accessory
2
) as far as it
goes. (Fig. 1)
8
Adjust the height, horizontal and vertical angle
of the monitor unit, and securely tighten the
installation screws using the supplied hexagon
wrench (Accessary
4
).
You can also adjust the monitor unit's forward
position by loosening the angle adjustment
knobs and adjusting the angle of the monitor
unit's installation stand.
Accessory
2
Accessory
3
Protective strip
Installation surface
Accessory
4
Shoe
Accessory
4
Tighten
Loosen
Fig. 1
B64-3528-00̲00̲KOS-L702.indb 9
B64-3528-00̲00̲KOS-L702.indb 9
07.2.6 8:11:57 PM
07.2.6 8:11:57 PM
