English
|
29
Installation/Removing the Unit
Installation
Firewall or metal support
Screw (M4 × 8 mm)
(commercially available)
Self-tapping screw
(commercially available)
Metal mounting strap
(commercially available)
Bend the tabs of the
mounting sleeve with a
screwdriver or similar utensil
and attach it in place.
⁄
• Make sure that the unit is installed securely in place. If the
unit is unstable, it may malfunction (for example, the sound
may skip).
Removing the hard rubber frame
1
Engage the catch pins on the removal tool and
remove the two locks on the upper level.
Upper the frame and pull it forward as shown in
the figure.
Catch
Lock
Accessory
2
Removal tool
2
When the upper level is removed, remove the
lower two locations.
⁄
• The frame can be removed from the bottom side in the
same manner.
Removing the Unit
1
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
2
Remove the screw (M4 × 8) on the back panel.
3
Insert the two removal tools deeply into the slots
on each side, as shown.
4
Lower the removal tool toward the bottom, and
pull out the unit halfway while pressing towards
the inside.
Screw (M4X8)
(commercially available)
Accessory
2
¤
• Be careful to avoid injury from the catch pins on the
removal tool.
5
Pull the unit all the way out with your hands, being
careful not to drop it.
B64-4049-00̲00̲E̲English.indd 29
B64-4049-00̲00̲E̲English.indd 29
08.2.5 4:25:09 PM
08.2.5 4:25:09 PM
