13
KDC-W4044UA/W4044UAY/W4044UG/W4044UGY
KDC-W413UA/W413UAY/W4544U/W4644UY
Key
Description of display
Description
FM
(UP)
AM
(DOWN)
/
Seek Stop Level
adjustment
(Manual)
M
N
N
V
0.00(V)
↔
5.00 (V) Normal (Local OFF)
/
Seek Stop Level
adjustment
(Manual)
M
N
L
V
0.00(V)
↔
5.00 (V) Normal (Local ON)
■
AUD
Adjustment
value memory
E
P
W
R
I
T
E
The display in the left column is shown when the data has
been written in E2PROM by pressing and holding the key for
2 seconds.
AUD
Mode clear
F
M
1
9
8 . 3
A
4
To clear FST adjustment (The display returns to the normal
display but the test mode is retained)
In the band where the local seek can be turned on or off (Local Seek ON/OFF), it is possible to turn on or off the local seek by pressing the [DISP]
key brie
fl
y.
After completing the FST adjustment, if You wish to clear the test mode, You can do this using the reset button.
■
Test mode speci
fi
cations in CD source
Display mode default: P-Time
• Procedure in CD-DA media (KTD-02A)
Key
Description of display
Description
Track up procedure
Every time pressed, jumps to the track shown below.
No.9
→
No.15
→
No.10
→
No.11
→
No.12
→
No.13
→
No.22
→
No.14
→
No.9 (recursive)
But in case the disc has 8 tracks or less, playback starts with
track No.1. (For both CD-DA and compressed
fi
le discs)
Track down procedure
Goes down by 1 track from the currently played track.
1
Jump procedure
Jump to No. 28 (Scratch 0.7mm for MUSIC line vibration testing)
2
Jump procedure
Jump to No. 14 (Blurring surface disc TCD-731RA Tr14)
3
Information display
Name of mechanism type
Mechanism version
9
B
2
0 :
Display of name of mechanism type and mechanism version
(Bolero version)
(Press the key while the display is what is shown in the left
column to change to the servo version display.)
Information display
Mechanism servo version
(USB)
S
E
R
V :
Display of mechanism servo table version
(Press the key while the display is what is shown in the left
column to display mechanism boot program version.)
Information display
Mechanism boot program
version (USB)
B
O
O
T :
Display of mechanism boot program version
(Press the key while the display is what is shown in the left
column to return to the normal display.)
5
Jump procedure
Jump to No.9 and No.22 (Preset 5
→
Track 22 in other track
than Track 22, and Preset 5
→
Track 9 in Track 22)
(For linearity check)
6
Jump procedure
Jump to No. 15. Set the volume value to “25”.
(For 20Hz 0dB DC protection false-operation FCT checking)
■
Audio-related test mode
Procedure
Note
Press the [AUD] key (main unit)
Press the [AUD] and [
∗
] keys (Remote control)
Enter audio adjustment mode (the initial item should be Fader, and then, Balance
→
Bass Level
→
Middle Level
→
Treble Level
→
SW Level
→
System Q
→
V-Offset
→
LPF Sub Woofer
TEST MODE
