Kenwood DPX-M3300BT, Instruction Manual

Page: 21 / 140

ENGLISH
13
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
Pair and connect a Bluetooth device for the first time
1
Press
B
SRC to turn on the unit.
2 Search and select the name of your receiver (“DPX-M3300BT”) on the
Bluetooth device.
“PAIRING” “PASS XXXXXX” “Device name” “PRESS” “VOLUME
KNOB” appears on the display.
• For some Bluetooth devices, you may need to enter the Personal
Identification Number (PIN) code immediately after searching.
3 Press the volume knob to start pairing.
“PAIRING OK” appears when pairing is completed.
Once pairing is completed, Bluetooth connection is established
automatically.
• “
” and/or “ ” indicator on the display window lights up.
• Depending on the settings made for
[BATT/SIGNAL]
(page 15), the
strength of the battery and signal of the connected device are shown on
the supplementary display (page 28).
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered
in the unit even if you reset the unit. To delete the paired device, see
[DEVICE DELETE]
on page 16.
• A maximum of two Bluetooth phones and one Bluetooth audio device can
be connected at any time. To connect or disconnect the registered device,
see
[PHONE SELECT] or [AUDIO SELECT] in [BT MODE] . (Page 16)
However, while in BT AUDIO source, you can connect to five Bluetooth
audio devices and switch between these five devices. (Page 17, 18)
• Some Bluetooth devices may not automatically connect to the unit after
pairing. Connect the device to the unit manually.
• Refer to the instruction manual of the Bluetooth device for more
information.
Bluetooth®
Auto Pairing
When you connect iPhone/iPod touch to the USB input terminal, pairing
request (via Bluetooth) is automatically activated if
[AUTO PAIRING] is set to
[ON]
. (Page 16)
Press the volume knob to pair once you have confirmed the device name.
Bluetooth — Mobile phone
Receive a call
When there is an incoming call:
•
[KEY 1] zone and [KEY 2] zone illuminate in green color and flash.
• The unit answers the call automatically if [AUTO ANSWER] is set to a selected
time. (Page 15)
During a call:
•
[LCD DISPLAY] zone illuminates according to the settings made for [COLOR
SELECT] (page 23) while [KEY 1] zone and [KEY 2] zone illuminate in green
color.
• If you turn off the unit, Bluetooth is disconnected.
DPX-M3300BT_E_B5A-3851-00_EN_1st Draft.indd 13 DPX-M3300BT_E_B5A-3851-00_EN_1st Draft.indd 13 9/10/2021 11:53:17 AM 9/10/2021 11:53:17 AM