English
|
5
Installation example
Install on the center part
Installation for Camera Unit
Installation for Camera Unit
1
Clean the surface to which the rear view camera
is to be installed. Use a cloth or other item to wipe
oil, wax, dust and any other dirt from installation
surface.
2
CAUTION
• Locate the rear view camera in the position you want it
installed. Adjust the angle of the rear view camera, and
install so that the camera doesn’t touch the car.
• When sticking to a glass surface, stick it on in a position
that assures the camera doesn’t touch the rear window.
2
Peel off the sheet on back of the camera bracket
(Accessory
3
) and stick it on.
2
CAUTION
• Press the camera bracket with your fingers to stick it to
installation surface. Touching the adhesive surface or
sticking the unit on a second time reduces adhesive
strength, which may result in the unit falling.
• If the temperature of the attachment surface is low,
warm with a hair dryer or other means before installing
to improve adhesive strength.
3
Attach the rear view camera to the camera
bracket (Accessory
3
) with the installation screws
(Accessory
4
).
2
CAUTION
• The rear view camera is attached so that the logo of
Kenwood is on the upper surface.
4
Adjust the angle so that bumper or rear edge of
the car is displayed at the bottom of the monitor
screen.
Glass surface
Screw (Accessory
4
)
Camera bracket (Accessory
3
)
Camera bracket (Accessory
3
)
Monitor screen
130°
96°
Bumper or rear edge of car
B64-3673-00̲English.indd 5
B64-3673-00̲English.indd 5
07.2.2 11:13:49 AM
07.2.2 11:13:49 AM
