Kentrox RMX-3200, Configuration Manual

Page: 213 / 388

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Relay Outputs: Configuring the Mediation TL1 Command
20-3
Configuring the Mediation TL1 Command

Note: For information about valid default Remote RMX-3200 TL1 commands, refer
to
Chapter 28: Remote RMX-3200 TL1 Commands . All available TL1
commands are documented in the Telcordia GR 833-CORE documentation.
To configure TL1 command patterns for a fan application:
1. Configure TL1 command pattern identifier
fanOn
with TL1 command
OPR-EXT-
CONT
, TID
mytid
and AID
1-fan
:
config mediation tl1command fanOn OPR-EXT-CONT mytid 1-fan
2. Configure TL1 command pattern identifier
fanOff
with TL1 command
RLS-EXT-
CONT
, TID
mytid
and AID
1-fan
:
config mediation tl1command fanOff RLS-EXT-CONT mytid 1-fan
3. (optional) Verify that TL1 command pattern
fanOn
has been configured properly:
show mediation tl1commands fanOn
The command response similar to the following displays:
4. (optional) Verify that TL1 command pattern
fanOff
has been configured properly:
show mediation tl1commands fanOff
The command response similar to the following displays:
Remote RMX-3200 TL1 VNEs can generate events in response to TL1 command s.
VNEs match up incoming command codes, TID s and AID s against preconfigured
command, TID and AID tuplets. If the VNE finds a match, it generates a
corresponding event. This event can trigger any response in the system and is
used to create a command for
relay output activation.
In this scenario, you will configure a fan control application that supports configured
TL1 commands OPR-EXT-CONT and RLS-EXT-CONT.
(Dub)>show mediation tl1commands fanOn
Name - fanOn
Command Pattern - OPR-EXT-CONT
TID - mytid
AID - 1-fan
(Dub)>
(Dub)>show mediation tl1commands fanOff
Name - fanOff
Command Pattern - RLS-EXT-CONT
TID - mytid
AID - 1-fan
(Dub)>