Kentrox RMX-3200, Configuration Manual

Page: 150 / 388

Remote RMX-3200 Version 5.2x Configuration Guide
Configuring Alarm Entries in the Central Alarm Table: Configuring an Alarm Entry for a Discrete Input
15-8
Configuring an Alarm Entry for a Discrete Input
To configure the open input alarm entry:
1. At the main prompt, configure description
Light switch
:
config alarm-entry input0_1 description Light Switch
2. Enable
tl1
alarm protocol support and set the TL1 alarm class to
eqpt
(equipment) and the TL1 service state to
sa
(service-affecting):
config alarm-entry input0_1 tl1 enable
config alarm-entry input0_1 tl1 eqpt
config alarm-entry input0_1 tl1 sa

Note: For information on configuring the TL1 NE and TL1 MUX that monitor the
alarm, refer to
Chapter 18: Configuring and Connecting TL1
Infrastructure .
3. Configure an event for alarm entry
input0_1
with the following settings:

Event originator
input 0/1
 Event trigger
open

Event severity level
major
 Alarm event message
Light off
.
config alarm-entry input0_1 event input 0/1 open major Light off
In this scenario, you will:

Configure an alarm entry description
 Configure TL1 alarm protocol support

Configure an alarm action that occurs when a light turns off, which opens an
input
 Configure an alarm action that occurs when a light turns on, which closes an
input.
Important: This scenario does not show how to configure the discrete input that is
associated with the alarm entry. For information on configuring
discrete inputs, refer to command
config discrete input
in the
Remote RMX-3200 Command Reference Guide .