REV D: 05/16/20
KENTMASTER MFG. CO., INC.
1801 SOUTH MOUNTAIN AVE., MONROVIA, CALIFORNIA 91016
UNITED STATES OF AMERICA
TELEPHONE: (626) 359-8888 FAX: (626) 303-5151
3 OF 21
OPERATING INSTRUCTIONS
ONLY TRAINED PERSONNEL ARE TO OPERATE THIS TOOL.
1.
TO ENSURE TOOL IS OPERATING PROPERLY, PERFORM FOLLOWING STEPS AT START OF EACH SHIFT:
•
MAKE SURE TOOL MOVES UP AND DOWN FREELY WHILE HANGING FROM BALANCER OVERHEAD.
•
WITH POWER TO TOOL TURNED ON, TEST TRIGGER FOR PROPER OPERATION.
•
DEPRESS EACH TRIGGER SEPARATELY. TOOL SHOULD NOT ACTIVATE. DEPRESS BOTH TRIGGERS.
TOOL SHOULD ACTIVATE.
•
IF TOOL HAS "ANTI-TIE DOWN" OPTION, BOTH TRIGGERS MUST BE DEPRESSED SIMULTANEOUSLY FOR
TOOL TO ACTIVATE.
2.
TO PERFORM WORK, HOLD TOOL FIRMLY AT BOTH HANDLES. SQUEEZE TRIGGERS TO ACTIVATE TOOL.
3.
POSITION TOOL AND PERFORM CUTTING OPERATION.
MAINTENANCE
ONLY TRAINED AND QUALIFIED PERSONNEL ARE TO PERFORM MAINTENANCE
AND SERVICE TO THIS TOOL.
THE COMPRESSED AIR DISTRIBUTION SYSTEM MUST BE LARGE ENOUGH TO SUPPLY AN ADEQUATE VOLUME OF CLEAN
AND DRY COMPRESSED AIR TO THE TOOL.
1.
MAKE ALL NECESSARY LINE CONNECTIONS TO THE TOOL.
2.
AN AIR FILTER-REGULATOR-LUBRICATOR (PART NO. 7200030) MUST BE INSTALLED IN AIR SUPPLY FOR EACH TOOL.
3.
FILL LUBRICATOR WITH KENTMASTER AIR MIST OIL (PART NO. 7903050). SET DRIP RATE ACCORDING TO
INSTRUCTIONS SUPPLIED. TURN ADJUSTMENT ON SIGHT FEED DOME TO INCREASE/DECREASE OIL DELIVERY.
MONITOR THE DEVICE BEING LUBRICATED AND READJUST IF NEEDED.
4.
TOOL REQUIRES GREASING AT START OF EACH SHIFT. GREASE FOUR (4) LOCATIONS USING KENTMASTER GREASE
GUN (PART NO. 4501470) AND GREASE (PART NO. 7903070).
5.
TOOL REQUIRES 40 S.C.F.M. OF AIR @ 90 P.S.I. AIR PRESSURE.
6.
FLUSH AIR MOTOR AT END OF EACH DAY’S USE BY SQUIRTING A FEW SQUIRTS OF KENTMASTER AIR OIL MIST (PART
7903050) DIRECTLY INTO THE AIR INLET PORT. RUN TOOL A FEW SECONDS TO COAT AND PROTECT THE AIR MOTOR
AND INTERNAL PARTS OF TOOL.
VIBRATION DATA
Model
Measuring
device
Average total vibration
Average A (8) exposure (hours)
Gain (dB)
based on 2.8 m/s2 average exposure
Rear Handle
Front Handle
Rear Handle
Front Handle
SL-1100
HVM-100
0.254
0.272
967
844
60
BLADE REMOVAL AND CLEANING
ALWAYS DISCONNECT POWER SUPPLY FROM TOOL BEFORE INSTALLING OR
REMOVING BLADE FROM TOOL.
ALWAYS WEAR WIRE MESH GLOVES WHEN INSTALLING OR REMOVING BLADE FROM TOOL.
1.
REMOVE COLLAR (ITEM NO. 2, FIG. NO. 1) USING WRENCH (ITEM NO.1).
2.
REMOVE BLADE (ITEM NO. 3, FIG. NO. 1).
3.
CLEAN ALL PARTS REMOVED WITH SOAP AND WATER.
4.
SHARPEN OR REPLACE BLADES WHEN NECESSARY.
5.
REASSEMBLE IN REVERSE ORDER.
!
WARNING
!
WARNING
!
WARNING
!
WARNING
