REV C: 06/06/18
OPERATING INSTRUCTIONS
ONLY TRAINED PERSONNEL ARE TO OPERATE THIS TOOL.
1.
TO ENSURE TOOL IS OPERATING PROPERLY, PERFORM FOLLOWING STEPS AT START OF EACH SHIFT:
•
MAKE SURE TOOL MOVES UP AND DOWN FREELY WHILE HANGING FROM BALANCER OVERHEAD.
•
WITH POWER TO TOOL TURNED ON, TEST TRIGGER FOR PROPER OPERATION.
•
DEPRESS EACH TRIGGER SEPARATELY. TOOL SHOULD NOT ACTIVATE. DEPRESS BOTH TRIGGERS.
TOOL SHOULD ACTIVATE.
•
IF TOOL HAS "ANTI-TIE DOWN" OPTION, BOTH TRIGGERS MUST BE DEPRESSED SIMULTANEOUSLY FOR
TOOL TO ACTIVATE.
•
THIS TOOL REQUIRES AN ELECTRIC BRAKE (INVERTER) THAT ACTIVATES WHEN EITHER TRIGGER IS RELEASED.
THIS ELIMINATES COASTING OF SAW BLADE WHEN TOOL IS DEACTIVATED.
INVERTER HAS TO BE INSTALLED WITH
1600520 AND 1600590 MODEL
2.
TO PERFORM WORK, HOLD TOOL FIRMLY AT BOTH HANDLES. SQUEEZE TRIGGERS TO ACTIVATE TOOL.
3.
SAW CARCASS THROUGH THE TAILBONE, MOVING DOWNWARD IN A STRAIGHT LINE.
4.
DO NOT EXERT EXCESSIVE PRESSURE. ALLOW TIME FOR TOOL TO CUT.
5.
CUT DOWNWARD IN A STRAIGHT LINE THROUGH SHOULDER AND NECK OF CARACASS.
MAINTENANCE
ONLY TRAINED AND QUALIFIED PERSONNEL ARE TO PERFORM MAINTENANCE
AND SERVICE TO THIS TOOL.
THE COMPRESSED AIR DISTRIBUTION SYSTEM MUST BE LARGE ENOUGH TO SUPPLY AN ADEQUATE VOLUME OF CLEAN
AND DRY COMPRESSED AIR TO THE TOOL.
TOOL REQUIRES GREASING AFTER EVERY 40 HOURS OF OPERATION. GREASE ONE LOCATION USING KENTMASTER
GREASE (PART NO. 7903070).
BLADE REMOVAL AND CLEANING
ALWAYS DISCONNECT POWER SUPPLY FROM TOOL BEFORE INSTALLING OR
REMOVING BLADE FROM TOOL.
ALWAYS WEAR WIRE MESH GLOVES WHEN INSTALLING OR REMOVING BLADE FROM TOOL.
1.
REMOVE SCREW (ITEM NO. 1, FIG. NO. 1).
2.
REMOVE PARTS (ITEM NO. 2-4, FIG. NO. 1).
3.
CLEAN ALL PARTS REMOVED WITH SOAP AND WATER.
4.
SHARPEN OR REPLACE BLADES WHEN NECESSARY AND LUBRICATE ALL PARTS.
5.
REASSEMBLE IN REVERSE ORDER.
KENTMASTER MFG. CO., INC.
1801 SOUTH MOUNTAIN AVE., MONROVIA, CALIFORNIA 91016
UNITED STATES OF AMERICA
TELEPHONE: (626) 359-8888 FAX: (626) 303-5151
3 OF 27
!
WARNING
!
WARNING
!
WARNING
!
WARNING
