S-MIX-PRO1600
10
Figure6.3.0 Computer IP change
1
）
Network connection
:
Use a network cable to connect the computer and matrix,
double-click to open the control software, click the "SETUP" button, if you control the matrix
through the network port, you need to set the IP of the computer and the IP of the matrix in the
same network segment, in the online port of the network port Select the computer's IP address
(click the "SETUP" button on the matrix touch screen to view the matrix network address), and
then click the "network port connection" button to connect. When all the buttons in the lower
right corner of the interface are displayed in green, the connection is successful. At this point,
click on the "Load" button on the interface to display the matrix configuration, as shown in
Figure 6.3.1.
