10
Capacity, Gas and Electrical Characteristics
Model
Approx. Capacity
Input
Gas
Type
Gas Supply Pressure
Manifold Pressure
Electrical Characteristics
U.S. Gals.
Litres
BTU/hr
Max.
in. WC (kPa)
Min.
in. WC (kPa)
in. WC (kPa)
Volts/Hz
Amperes
153.331010
25
94.6
100,000
Nat.
14.0 (3.49)
5.0 (1.25)
4.2 (1.05)
120/60
2.5
153.331000 HA
25
94.6
100,000
Nat.
14.0 (3.49)
5.0 (1.25)
4.2 (1.05)
120/60
2.5
Minimum gas supply pressure must be maintained under both load and no load (dynamic and static) conditions.
Manifold Pressure is preset on the gas valve by the manufacturer; DO NOT ATTEMPT TO ADJUST!
Thermal effi ciency is 90%.
If the hardness of your water supply is more than of 12 grains per gallon (200 mg/L), if your water supply is acidic or otherwise impure,
the water supply must be treated with approved methods.
Minimum Clearance To Combustibles
Service Clearance
Test Pressure
P.S.I.
Top
Front
Vent
Back
Sides
Floor
Front
Sides
0
0
0
0
0
0
21” (53.3 cm)
12” (30.5 cm)
300
This appliance must be installed in accordance with local codes or, in the absence of local codes, the “National Fuel Gas Code” ANSI
Z223.1/NFPA 54.
Not for installation in a Manufactured Home (Mobile Home).
This water heater is suitable for water (potable) heating only.
This water heater is suitable for installation in a closet or alcove.
ROUGH IN DIMENSIONS
FIGURE 2
INSTALLATION CONSIDERATIONS
Left Side View
Top View
Dimension shown are in inches [cm]
Summary of Contents for ELITE 153.331000
Page 3: ...3 GENERAL SAFETY ...
Page 56: ...56 R O N M L K J I H G F E D C B A T Q S P 12 15 14 U 10 7 6 5 4 3 2 1 Z Y X W V 11 9 8 13 ...
Page 58: ...58 NOTES ...
Page 59: ...59 NOTES ...
