Kenmore 796.488x2800, Service Manual

Page: 29 / 51

28
DETERGENT DOES NOT FLOW IN
Refer to
NO WATER SUPPLY
Put the detergent in the
correct place.
Check the wiring.
Clean the dispenser.
Is water supplied?
Is the detergent caked or hardened?
Are receptacles correctly connected to the
terminals of the INLET VALVE ASSEMBLY?
Has detergent been put in the correct compartment
of the dispenser?
YES
YES
YES
NO
NO
NO
NO
SPIN TROUBLE
Press the START/ PAUSE button 2 times in QC
Test mode, is the drum spinning at low speed?
Check during spin if the frequency of the water
level is 248 or more.
Is it disconnected, or disassembled?
[Red:3pin (1), NA:4pin (2)]
Check the motor connector, Is the resistance of
the terminal the same as the figure?
MOTOR TERMINAL
Replace the MAIN PWB ASSEMBLY
Resistance of terminal:
¥L-¥M / ¥M-¥N / ¥N-¥L : About 5
Ω
- 15
Ω
Check the SENSOR SWITCH
ASSEMBLY or HOSE(Pressure).
If the problem is on the SENSOR
SWITCH ASSEMBLY or the
HOSE, replace the SENSOR
SWITCH ASSEMBLY or the
HOSE.
Normal
Correct the connection.
Replace the STATOR
ASSEMBLY
YES
YES
NO
NO
NO
NO
YES
YES
¥N ¥M ¥L