17
8. TROUBLESHOOTING
ERROR
SYMPTOM
CAUSE
WATER INLET
ERROR
1
IMBALANCE
ERROR
2
DRAIN
ERROR
3
OVER FLOW
ERROR
4
PRESSURE
SENEOR
ERROR
5
DOOR OPEN
ERROR
6
HEATING
ERROR
7
• Correct water level (2 level) is not reached within 8 minutes
after water is supplied or it does not reach the preset water
level within 25 minutes.
• The load is too small.
• The appliance is tilted.
• Laundry is gathered to one side.
• Non distributable things are put into the drum.
• Door not all the way closed.
• Loose electrical connections at Door switch and PWB
Assembly.
• The DOOR SWITCH ASSEMBLY is out of order.
• Not fully drained within 10 minutes.
• The SENSOR SWITCH ASSEMBLY is out of order.
• The THERMISTOR is out order.
• Water is overflowing (over 8 level).
If is displayed, the drain pump will operate to the
drain water automatically.
8-1. SAFETY CAUTION
8-2. ERROR MODE SUMMERY
If you press the START/PAUSE button when an error is displayed, any error except
will
disappear and the machine will go into the pause status.
In case of
,
,
if the error is not resolved within 20 sec., or the in case of other errors,
if the error is not resolved within 4 min., power will be turned off automatically and the error code will
blink. But in the case of
, power will not be turned off.
There’s built-in AC 120V and DC power in output terminal of PWB assembly in common. Be careful electric
shock when disconnecting parts while trouble shooting. (Wear Electro Static Discharge gloves when working.)
After cutting off the power when changing PWB assembly, disconnect or assemble.
Be careful static when handling PWB assembly, and use Electro Static Discharge plastic pack when
delivering or keeping it.
Summary of Contents for 796.488x2800
Page 2: ...P No MFL30599120 ...
Page 15: ...6 WIRING DIAGRAM PROGRAM CHART 14 ...
Page 16: ...15 ...
