16
Install the Hood (Standard Installation)
1. Run house power cable between service panel and hood
location. For hood with power cable access located on
back of hood, run the house power cable into the hood
through the strain relief previously installed in step 5 on
page 9. For hood with power cable access located on
top, tighten the strain relief to the power cable before
inserting the strain relief in the knockout hole.
2. Hang hood from (2) mounting screws previously installed.
Slide hood back towards wall until mounting screw heads
are engaged in narrow end of keyhole slots in top of hood.
Tighten screws securely and maintain a hold on the hood
until completing step 3.
DUCTED INSTALLATIONS ONLY
4. Connect the ductwork to the hood and use metal foil duct tape to make joints secure and air-tight. Make sure the
damper assembly (or round duct plate) enters the ductwork and that the damper opens and closes freely.
NOTE: Two installers are recommended because of the weight of this hood.
BACK OF HOOD
S
CREW
PREVIOUSLY
TIGHTENED
IN
STEP
2
3. Secure the hood to the cabinet using 2 no. 8 x 5/8” round
head wood screws (screws ncluded in parts bag). Insert
1 screw per side, in the slots (as shown beside. Attach
power cable to the hood using the strain relief.
