13
Plug
Socket
Sleeve
Your grill can be converted to natural gas. The
conversion must be performed by a qualified gas
technician. The following listed Natural Gas Conversion
Kit (sold separately) are required for the conversion.
Natural gas conversion kit
Kenmore Model # 10478
(Manufacturer Part No.: RB2818T-KIT)
To purchase a Natural Gas Conversion kit call Sears at
1-800-4-MY-HOME
○
R
Natural Gas Connection Preparation:
1.
Turn off gas supply, and then remove cap on gas
supply side.
2.
Recommended: Install a shut-off valve on
gas supply side before installing the socket.
3.
Socket should be installed by an authorized
technician in accordance with the national fuel gas
code (NFPA 54/ANSI223.1).
4.
Before inserting plug, turn on gas supply and leak
test all connections including the stem of the shut-off
valve and the opening of the socket. For best results,
use an ammonia-free soap & water solution.
Operating Instructions:
1. To connect, push back socket sleeve.
2. Insert plug and release sleeve.
3. Push plug until sleeve snaps forward. (Gas will flow
automatically. Failure to connect plug properly to
socket will inhibit gas flow to the appliance.)
To disconnect
1. Pull Sleeve back. Pull plug out of socket. (Gas is
automatically shut off.)
2. Close shut-off valve or turn off gas supply, and replace
dust caps on socket and plug.
Natural Gas
Now that your grill is converted to Natural Gas use, it is
set for 7-inch water column (WC) pressure, and cannot
be used with Propane Gas. Gas pressure is affected by
gas line size and the length of gas line run from the
house. Follow the recommendations in the chart below.
From House to Grill
Distance Tubing
Size
Up to 25 ft.
3/8 in. diameter
26-50 ft.
1/2 in. diameter
51-100 ft.
2/3 of the run: 3/4 in.
diameter
1/3 of the run :1/2 in. diameter
Over 101 ft.
3/4 in. diameter
Natural Gas Conversion Kit
Sleeve
Socket
