9
Set-up kena
®
Digital Microscope
kena can be set up in a matter of minutes. To get the most out of this amazing
teaching tool, follow these step-by-step directions:
1. After unpacking the box, unwrap kena from the protective plastic bag.
2. Before beginning, review the parts of the kena microscope:
a. The
Camera Head
has 4 main features:
i. The gray
Camera Head
has a
capture button
on the top of
the unit next to the molded Ken-A-Vision logo. Use this button to
capture still images.
NOTE:
Another way to capture still images is through the
software.
ii. The
turret
objectives of 2x, 4x and 10x result in standard
magnifications of 20x, 40x and 100x (respectively) under normal
screen use. The turret also houses the upper LED light.
iii. The silver
upper LED light button
is located below the fac-
tory-installed USB cable. Press this button to turn on/off the
upper LED light located in the turret.
iv. The black 6 foot / 1.8 meter
USB cable
is factory-installed and
plugs directly into a USB port.
This cable powers kena.
b. The
Base Unit
has 5 main features:
i. Use the
2 focus knobs
on both sides of the base to move the
camera head up and down or to load and eject it.
ii. The
red handle
is for carrying the unit and also functions as a
cable wrap
for the USB cable when storing the product.
iii. The base has a
battery door
for installation of four (4)
standard "AA" batteries. These batteries power the center lower
illumination for viewing slides and transparent specimens. Note
the "+" and "-" pole symbols on the door for correct placement.
iv. Use the silver
lower LED light button
located on the base
next to the silicone pad to turn on/off the
center lower light
(transmitted light).
Summary of Contents for kena T-1050
Page 1: ...kena Instruction Manual T 1050...
Page 2: ...2...
