EN
to change feed rolls, do the following:
1.
Remove the feed rolls by unscrewing their fixing screws.
2.
Insert the new feed rolls into their place.
3.
Select the right groove according to the wire you are using. See the instructions below.
4.
Fasten the feed rolls with their fixing screws and drive the wire into the welding gun as
instructed in chapter 2.4 'Installing the welding gun'.
to change the feed roll groove, do the following:
Each feed roll has two grooves for different filler wire diameters. When changing the feed rolls
select the groove according to the wire you are using.
1
1
Move the feed roll selector plates from one side to another.
Choose the correct groove by moving the groove selector plate (1) from one side to another in
feed roll as shown in the left-hand picture above.
Move also the gear wheel selector plate.
When changing the feed roll groove you must also set the gear wheel to new position. This is
done by changing the gear wheel selector plate to the other side of the wheel.
9
A
rcF
eed 200, 300, 300P
, 300R
C / © Kemppi O
y / 1117
