Kemlan CELESTIAL 900, Installation & Operating Instructions Manual

Page: 4 / 22

MINIMUM CLEARANCES FOR THE CELESTIAL 900 SOLID
FUEL APPLIANCE INSTALLED WITH METAL
FRAMING AND DEFAULT FLUE KIT
300
300
MINIMUM CLEARANCES:
*As per Clause 3.3.2 of AS/NZS 2918:2001 for floor protector
construction requirements. This measurement only applies when
unit is 200mm above floor. (refer hearth measurement drawing if
unit is higher than 200mm from floor.)
** This is the minimum allowable distance to any combustible
material behind and to the side of the unit.
Glass viewing area- 728mm wide x 268mm high
Flue pipe- ø150mm
– top exit
Shipping weight- 185 kg
All dimensions shown are approximate. Check all dimensions
accurately before installation. Before installing refer to the
installation instructions.
In line with our policy of continuous improvement, we reserve the
right to alter specifications without notice.
CONSTRUCTION:
6 mm heavy duty steel firebox
– fully welded
25mm thick firebrick lined floor, back and sides
19mm ceramic baffle plates
NOTE:
The floor protector consists of a 18mm thick Bellis Board or similar
material which has a thermal resistance of 0.1m² k/W, per 9mm thick
sheet
PERFORMANCE:
Heating capacity
– 220-320m2 (23-33 squares)
Average peak heat output
– 12.7kW
Average Particulate emission - 0.6g/kg
Average efficiency
– 60%
Heating capacity of this appliance is given as a guide only and may
vary depending on the climate zone and type of dwelling (floor plan
and degree of
insulation). Consult your local authorised distributor to determine
realistic expectations for your home.
Heat output and fuel consumption of this appliance is dependent on
the moisture content, size, loading geometry and the type of
hardwood used.
The appliance complies to the safety standards
AS/NZS 2918. When in use some parts may become hot. A suitable
fireguard is recommended where the very young, elderly or infirm are
concerned.
200
20/08/2020 ver. 29 4
- SIDE OF FIREBOX TO COMBUSTIBLE MATERIAL
- BOTTOM OF FIREBOX TO FLOOR