![background image](http://html1.mh-extra.com/html/kelvinator/kse362hpca/kse362hpca_installation-manual_4020082012.webp)
12 installation diagram
Kelvinator heat pump hot water system
Installation diagram
uncontrolled
hot water outlet
(kitchen, laundry)
refer to local electrical
requirements to
ascertain whether
isolation switch is
required
under heat pump (drain assembly
viewed from back of unit) –
discharge condensation drain
hose to a suitable location
tempered
(50°C)
hot water
outlet
(bathrooms)
tempering
valve
25mm
diameter
conduit
20mm
diameter
conduit
outlet
inlet
isolating
and non
return
valve
pressure limiting
valve (600kPa)
may be required
if pressure
exceeds 600kPa
cold water
expansion
control valve
(700kPa) may be
required refer to
local plumbing
guidelines
cold
inlet
continuous
supply input
continuous
supply input
storage tank
heater output
150mm
Ø
2.5mm
storage tank
heater output
off peak
supply input
sensor cable plugs in here
refer to the electrical section for more detail
on wiring the heat pump
continuous wiring configuration
off peak wiring configuration
All numbered items are supplied with the hot water system. Please refer to the Components list on pages
6 & 7 for details. Items which are not numbered are not supplied and need to be supplied by the installer in
accordance with local plumbing requirements. Installation of this hot water system must be completed by
an authorised and licensed person in accordance with all local regulations, including AS3500 plumbing and
drainage requirements and AS3000 electrical wiring standards.
25mm
diameter
conduit