Kelvinator KGC20BLA, Installation Manual

Page: 14 / 24

14 remote controller Kelvinator Gas Continuous Flow hot water system
Remote controller installation
1. Crimp the fork terminals to the wires. Minimum 18AWG
wire (No polarity).・Maximum 100m long
15
2. Attach the fork terminal to the connector base of the
backside unit with two screws tight.
3. Install the wiring downward through the cable trench and
out the bottom of the connector base.
4. Attach the remote control on the wall with the two
included screws. (If you need to attach the remote control
to gyprock, you should use the anchor plug.)
15
use the fork terminals
25mm
remote control
wiring
connector base
83.
5m
m
45mm
warning
• The remote controller must be installed inside
and in an area that isn't wet or damp as it is NOT
water resistant. This includes bathrooms and other
potentially wet areas.
• DO NOT position the remote controls in the vicinity
of chemicals.
• DO NOT position the remote controls over a cooker,
grill or toaster.
• DO NOT position the remote controls where materials
may spill onto them.
• Please note if the controls are to be fitted to a metal
surface an insulation plate should be provided behind
the mounting position.