warning
• Contact an authorised installer for installation of this hot
water system.
• Contact an authorised service technician for repair or
maintenance of this hot water system.
• Installation work must be performed in accordance
with national standards by suitably licensed installers
only. Wrong connection can cause over heating or fire.
• This hot water system should be installed in accordance
with AS/NZS 3000 and your electricity suppliers rules.
For the installer
The installation must be done in accordance with the
information supplied in the installation manual supplied
with the hot water system.
All other relevant National, State or Local regulations must
also be conformed with and these include (but are not
limited to):
• Australian Standard AS/NZS3500.1 - Water Supply
• Australian Standard AS/NZS3500.4 - Hot Water Supply
• Australian Standard AS/NZS3000 - Electrical Installations
warning
This heat pump hot water system is approved for connection
to either continuous tariff or extended off peak tariff only
(also referred to as off peak 2 tariff where there may be
approximately 19 hours of power available per day). This
heat pump is NOT suitable for connection to night rate
tariff power supply (also referred to as off peak 1 where
there may be approximately 8 hours of power available per
day). Connecting to night rate power supply may cause the
automatic sanitisation function to not always comply with
Australian Standard AS 3498 for legionella control.
warning
This hot water system delivers water in excess of 50°C.
Water temperatures above 50°C can cause severe burns,
scalding or death. Feel the water temperature before
bathing or showering. Do not leave children unsupervised.
Under AS/NZS 3500 the temperature of the hot water
being delivered must not exceed 50°C at any outlets used
primarily for purposes of personal hygiene. To comply with
these standards, a tempering valve set (supplied) must be
fitted to this hot water system.
warning
Do not operate or stop the hot water system by
switching on or off the power
Do not use a damaged or unspecified power
supply cable
Do not allow water to run into electric parts of
the hot water system as it may cause failure or
electric shock
Do not open any part of the hot water system during
operation as it may cause electric shock
Do not store flammable gas or combustibles such as
gasoline, benzene, paint thinner etc near the hot water
system as this may cause corrosion or an explosion
Do not disassemble or modify the hot water system
as it may cause failure and electric shock
Important safety instructions
Kelvinator heat pump hot water system
important safety instructions 3
