14
BEFORE USING THE MACHINE
* IMPORTANT!
Check and tighten all bolts, nuts and all connections and specially the
clamp sleeve for the pulley
Check clamp sleeve for the pulley. The bolts
should be tightened at regular intervals.
Tighten and check the belt tension if neces-
sary.
* Check knives/flails, make sure they are installed properly. Replace broken, cracked or worn
knives / flails.
* Check all protective covers, protective devices. Remove any transport locking device.
* Lubricate the drive shaft and other lubrication points .
OPERATION
Only people who understand the safety information and instructions in this manual may operate the
equipment. Be alert and careful when working with the machine and only use the equipment or prod-
uct in the manner described in this manual. When working with equipment that has moving parts,
there is always the risk of injury. Be careful when working with equipment equipped with hydraulic
hoses ,oil under pressure can penetrate the skin. Seek medical attention immediately if this occurs.
Al-
ways work alone with the equipments that are defined as single purpose equipment. Never overload
the implement. Respect the equipment’s danger zone.
Connecting the machine
* Attach the machine onto the tractor’s rear three point.
* Connect the PTO shaft. Anchor the chain well.
* Connect hydraulic hoses to the tractor’s double- acting hydraulic outlet
* Ready for use.
CUTTING
* Check the area to be cut and remove objects and trash that can be caught and thrown away by the
blades.
* The amount of grass to be cut determines the speed forward; Low speed usually gives the best
results. It is best to cut grass when dry. Cutting wet grass can cause clogging, which leads to grass
lumps behind the cutting unit. When cutting very high grass, raise the cutting level and cut the same
surface twice - the second time with lower cutting level, allow at least 24 hours between first and
second cutting to allow the grass to dry out.
* Lower the cutting unit on the ground. Connect the PTO shaft so that the blades start to rotate.
