Keller ITS CellaPort PT 120, Operating Manual, Page: 34 / 72

Operating manual PT 11x, 12x,13x
28
------------------------------------------------------------------
>H
------------------------------------------------------------------
Mainmenu
------------------------------------------------------------------
E: Quick access EPSILON
1: [LAMBDA 1] A: Quick access FILTER
T: Quick access Ao1 SOURCE
C: [I/O] Y: Quick access Ao1 SCALE BEGIN
K: [CALIBRATION] Z: Quick access Ao1 SCALE END
H: Show this help-site J: Show diagnosis
W: Show ambient temperature Q: Show calibration data
X: Show measure temperature P: Show channel parameters
------------------------------------------------------------------
17.2 View Current Configuration
Command „P“ shows you how your CellaPort is currently configured. At a
glance you can view the following parameters:
------------------------------------------------------------------
- PT 110 AF1 0-1000C - 00/00104 - Job - 10.06.13 -
- PT10SW101/0 SP 8 - 14 um Version 01.02 10.07.13 -
------------------------------------------------------------------
L1 range .... 0.0 - 1000.0 C DISPLAY source ....... lambda 1
L1 epsilon ............ 99.3 %
L1 transmission ....... 99.9 %
L1 backc. ................. off
L1 linearization .......... off
L1 filter ........... automatic
L1 memory type double 2.00 s GRN.LED source .... ATD tAct L1
L1 memory filter .......... off GRN.LED function level/signal
Unit .................. Celsius GRN.LED delay time ... 0.00 s
Terminal assigned to ...... USB GRN.LED hold time .... 0.00 s
Autoprint ......... on (cyclic) BUZZER source ATD triggered L1
Print cycle time ..... 0.1 s BUZZER function level/signal
Protocol address .......... 001
Display ........... temperature BUZZER delay time ... 0.00 s
Key lock .................. off BUZZER hold time .... 1.00 s
------------------------------------------------------------------
>
At the top left, there is a list of data acquisition parameters for ratio mode
(quotient). The right-side column shows LED/Buzzer configuration. At the
bottom left you will find general settings.
17.3 Submenus
17.3.1 Configuration
Press key "1" to access all data logging parameters for Lambda 1.
------------------------------------------------------------------
Submenu LAMBDA 1
------------------------------------------------------------------
L1 epsilon ............ 99.3 %
L1 transmission ....... 99.9 %
L1 backc. ................. off