Keithley KUSB-3160, User Manual

Page: 43 / 69

Supported Device Driver Capabilities
23
3
3
3
3
3
3
3
3
3
Co
unter/
Ti
mers
(c
ont.)
Level Change Gate Type with Input
Debounce Support
OLSSC_SUP_GATE_LEVEL_
DEBOUNCE
Inte
rr
up
t
Interrupt Support
OLSSC_SUP_INTERRUPT
Yes
d
FIF
O
s
FIFO in Data Path Support
OLSSC_SUP_FIFO
Output FIFO Size
OLSSC_FIFO_SIZE_IN_K
Processor
Data Processing Capability
OLSSC_SUP_PROCESSOR
Softw
ar
e
Ca
libr
ation
Software Calibration Support
OLSSC_SUP_SWCAL
a. A total of eight banks of eight digital I/O lines and four banks of eight dedicated digital input
lines exist on the board. You can configure the nondedicated banks for either digital input or
digital output when you configure the device driver. Refer to the
KUSB-3160 Getting Started
Manual for more information on configuring the device driver.
b. Continuous digital input operations are supported by digital input banks 10 and 11 only.
c. The number of subsystem elements depends on the bank size or resolution established in the
driver configuration dialog. Values for resolution are 8, 16, 24, or 32. If you are using digital
input banks 10 and 11 in continuous mode, the resolution is always 16 bits. Refer to
page 10
for more information on resolution.
d. Digital banks 10 and 11 can generate an interrupt on a bit-by-bit basis. You configure the
digital lines to interrupt using the Open Layers Control Panel. Refer to the KUSB-3160 Getting
Started Manual for more information.
Table 2: KUSB-3160 Supported Options (cont.)
KUSB-3160 A/D D/A DIN DOUT SRL C/T
Total Subsystems on Board 0 0 12
a
8
a
0 0