Model 4299-2 Instructions
PA-909 Rev. C / May 2007
5
3. Place the instruments side-by-side as they will be installed in the rack (refer to Figure 3).
4. Secure
Front Rack Ear
(2602-333) to outside of each instrument using two
Pan Head Screws
(8-32x3/8PPH ) on the same side as the
Rear Rack Mount Bracket
(2602-334).
NOTE
Knuckles on Hinge (2602-328) must face front of units.
5. Secure one-half of
Hinge
(2602-328) to right instrument and other half of
Hinge
(2602-328) to left
instrument using two
Flat Head Screws
(8-32x3/8PFH) on each half. Check knuckle orientation on
hinges—knuckles must face front of units.
6. Bring the two instruments together and secure by inserting
Pin
(FA-352) to assemble the
Hinge
(2602-
328).
7. If the two K.I. units are of the same length, remove one rear bezel screw from each unit as shown (Figure
5). Install the
Rear Bracket
(2304-327) securing it (and the applicable rear bezels) with the #6-32x5/8PPH
screws and washers supplied.
Figure 3
Secure instrument together
RANGE
AM
PS
350
V
PEA
K
AU
TO
SH
IF
T
LO
CA
L
PO
W
ER
RANGE
HO
LD
CO
NF
IG
HA
LT
Integra Series
Pan Head Screw (Phillips)
2 Places(See Note**)
Pan Head Screw (Phillips)
2 Places
(See Note**)
Front Rack Ear
(2602-333)
RANGE
AM
PS
350V
PE
AK
AU
TO
SH
IF
T
LO
CA
L
PO
W
ER
RANGE
HO
LD
CO
NF
IG
HA
LT
Integra Series
Flat Head Screw (Phillips)
2 Places on each(See Note**)
Hinge
(2602-328)
Rear Bracket
(2304-327)
(See Note*)
Use Existing
Rear Bezel Screws
Front Rack Ear
(2602-333)
Pin
(FA-352)
Front Mounting
Holes used for the
2100 DMM or
Agilent product
Rear Mounting Holes
used for any KI product
other than the 2100
DMM
Note:
*Rear bracket used only with Keithley produdcts of
the same length, excluding the 2100 DMM
**When installing a 2100 DMM or Agilent unit, use
M4x12 screws in the front mounting holes; otherwise
use 8-32x3/8 screws in rear mounting holes.
