Model 4299-2 Instructions
PA-909 Rev. C / May 2007
3
Step 1. Prepare instrument
To prepare the instrument for mounting, remove the handle, the mounting ears, and both rear feet. The following
information outlines this process.
1.
Remove the handle
—The handle serves as an adjustable tilt-bail. Adjust its position by gently pulling it
away from the sides of the instrument case and swinging it up or down. To remove the handle, swing the
handle below the bottom surface of the case and back until the orientation arrows on the handles line up
with the orientation arrows on the mounting ears (refer to Figure 1). With the arrows lined up, pull the ends
of the handle away from the case.
2.
Remove mounting ears.
•
Remove the screw that secures each mounting ear.
•
Pull down and out to remove each ear.
Figure 1
Remove handle and mounting ears
Mounting ear
Screw
Handle
Mounting ear
2.
Remove both rear feet from the instrument
by pulling out the rubber feet and then removing the screws
underneath.
NOTE
Do not re-install the feet mounting screws. Save all parts removed for future bench top use of
the instrument.
