Section 7: TSP command reference
2606B System SourceMeter® Instrument Reference Manual
7-80
2606B-901-01 Rev. B / May 2018
Also see
(on page 7-80)
(on page 7-81)
display.trigger.EVENT_ID
This constant is the event ID of the event generated when the virtual front-panel TRIG key is pressed.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Constant
Yes
Usage
eventID
= display.trigger.EVENT_ID
eventID
The trigger event number
Details
Set the stimulus of any trigger event detector to the value of this constant to have it respond to virtual
front-panel trigger key events.
Also see
None
display.trigger.overrun
This attribute contains the event detector overrun status.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (R)
Yes
Display trigger clear
Instrument reset
Recall setup
Not saved
false
Usage
overrun
= display.trigger.overrun
overrun
The trigger overrun state
Details
Indicates if a trigger event was ignored because the event detector was already in the detected state
when the TRIG button was pressed.
Indicates the overrun state of the event detector built into the display.
This attribute does not indicate whether an overrun occurred in any other part of the trigger model or
in any other detector that is monitoring the event.
Example
overrun = display.trigger.overrun
Sets the variable
overrun
equal to the
present state of the event detector built into
the display.
Also see
(on page 7-79)