24
5.
Replace the end cap and plastic button on the new thumb button assy, rotate the end
cap until the “+” or “-“ indicator is facing towards the user. Using the 5/64” allen
wrench, tighten the set crews ¼ to ¾ of a turn past finger tight (Do not over tighten).
6.
Twist the grip sleeve back toward the end cap until there is no visible gap between the
grip sleeve and the end cap.
7.
Now slip the collar back toward the grip sleeve until it is flush with the grip collar,
using the 5/64” allen wrench, tighten the set screws ¼ to ¾ of a turn past finger tight
(Do not over tighten).
8.
This is what the grip sleeve and end cap should look like when you are done.
9.
Allow at least 4 hours for the alcohol to dry.
NON-THUMB BUTTON GRIP
Follow the same instruction as you would for the thumb button grips.
NOTICE:
If it is
necessary to use alcohol or petroleum based solvents to remove old adhesive from grips,
care must be taken to prevent these solvents from contacting the upholstery, and the
cleaned area must be waxed as soon as possible to prevent corrosion of the chrome.
NOTICE:
GRIP COLLARS ARE ONLY USED ON CERTAIN MACHINES.
CONTACT SERVICE DEPARTMENT FOR LIST OF CORRESPONDING
MACHINES.
Summary of Contents for Keiser 300
Page 1: ...Keiser 300 Air 300 Parts and Maintenance Manual...
Page 3: ...3...
Page 5: ...5...
Page 6: ...6...
