08
INSTALLATION INSTRUCTIONS
TRIPLE TRAINER
STEP-BY-STEP INSTALLATION GUIDE
1
PREPARE DRILL HOLES FOR ADHESIVE
•
Clean drill holes with a Wire Tube Brush.
•
Collect dust/debris using a HEPA Vacuum.
CONCRETE WITH FLOORING ONLY
•
Fit each 1” (25.4 mm) diameter hole cut with Spacers
(supplied) to match flooring height.
NOTE: Multiple Spacers in each hole is OK.
Example: 3/8” flooring height requires 1/4” and 1/8”
Spacers per hole.
ADHESIVE APPLICATION
•
Set the Floor Mount Plate aligned with the drill holes.
IMPORTANT:
Installation over Flooring — check Spacers
do not interfere with Floor Mount Plate seating. If any gaps
are present, fit the holes with the appropriate size Spacers.
•
Follow the Adhesive Manufacturer’s application instructions.
IMPORTANT:
Adhesive is fast-curing with very short
working time. The next step (
Step 4) must be performed
immediately after the Adhesive is applied.
NOTE: Floor Mount Plate Kit installation procedure shown. Pre-assembled Triple Trainer installation is similar.
DRILL USING THE FLOOR MOUNT PLATE AS THE DRILL PATTERN (QUANTITY 3 DRILL HOLES)
IMPORTANT:
Check the Floor Mount Plate alignment as each hole is drilled to avoid costly rework.
CONCRETE OR CONCRETE WITH FLOORING UP TO 5/8” (16 mm)
•
Drill the length of the screw anchor, including overdrill, into the concrete:
4” (102 mm) anchor screw + 1/2” (13 mm) overdrill depth = 4-1/2” (115 mm)
CONCRETE WITH FLOORING OVER 5/8” (16 mm)
•
Flooring over 5/8” (16 mm) thick requires a 3/8” diameter anchor with appropriate length (not supplied).
•
Drill the length of the anchor, including overdrill, into the concrete, as specified by the manufacturer.
•
Cut a 1-inch diameter hole into the flooring material, centered over each drill hole. This is to clear flooring material
for spacers to be installed later in Step 2.
Floor Mount
Plate
CONCRETE,
FLOORING UP TO
5/8” (16 mm)
CONCRETE
WITH FLOORING
OVER 5/8” (16 mm)
4” (102 mm)
Drill length
of Anchor
1/2” (13 mm)
overdrill
Overdrill per Mfg
Specification
WEAR SAFETY
GLASSES
2
3
Collect Dust/Debris
using a HEPA Vacuum
CONCRETE
WITH FLOORING
Fit Spacers
Clean Drill Holes with Wire Tube Brush
1” (25.4 mm)
dia. hole cut
in Flooring
3/8” dia.
