3 Installation
Hybrid Inverter
User Manual
22
Table3-1 Expansion bolt specification
Item
Base module
Battery pack
Expansion bolt
M10
M6
A
Φ
12.5mm
Φ
8mm
B
75mm~80mm
40mm~45mm
During drilling, please ware safety goggles and a dust mask to prevent dust from entering your eyes.
After drilling, please clean the scrap in the installation holes, and then perform the installation.
Ensure that the installed floor is flat and horizontal. If not, please use gasket to make the floor
horizontal. Ensure that the installed wall is flat and horizontal (flatness within 4mm) and the installed
floor horizontal angle is 0°. If not, please use gasket to make the floor horizontal.
Keep the installed place far away from the tube of water, electricity or gas, which is to avoid affect
the installation.
After drilling, please clean the scrap in the installation holes, and then perform the installation.
Step 5 Fix the base module to the installed floor, as shown in Figure3-7.
Figure3-8 Fix the base module
Step 6 Lead the cover plate into the base module and fix it with screws, as shown in Figure3-10, Figure3-11.
