7
A.
Align the fixing plate on internal face of the opening, so
that the rails of the Safety Gate match up with the top of the
Guardrail System. Select the correct U Bolt & pass it through the
Steel Safety Clamp & around the support leg/structure and feed
through the top holes of the fixing plate.
TOOLS REQUIRED
You will need the following in order to install the
Kee Gate:
• Marker Pen
• Tape Measure
• 1 No 15/16” Ring Spanners
• 3/16” Allen Key
• 1 No ½” socket
• 1 No 11/16” socket
• 1 No 15/16” socket
• Torque Wrench 10- 60 Nm approx
• Small Magnetic Level
Mounting Gate to Upright
Establish that the gate will close in direction of hazard!! Fail-
ure to do so could result in Death or serious injury.
D.
Torque all nuts/U Bolts to 25Nm using the 11/16” or ½”
socket and torque wrench.
C.
Select the correct U Bolt & pass it through the Steel Safety
Clamp & around the support leg/structure and feed through the
top holes of the fixing plate. Using a ½” or 11/16” flat washer
and nut connect the U bolt to the Support Leg/Structure and
tighten.
B.
Using a 11/16” or ½” flat washer and nut connect the U bolt
to the Support Leg/Structure and tighten.
E.
To extend the gates width to the required opening simply
loosen the hex nuts and bolts on the top guardrail using a 3/16”
Allen Key and ½” socket.
Mounting and tensioning single gate spring
