LSMD-121 OPERATION
17
1. INITIAL PREPARATION
Insert batteries into the Remote Control unit by following the procedure described in the
"REMOTE CONTROL BATTERY INSTALLATION" section in this manual.
Follow the procedure described in the "MENU OPERATION" and "AUTO PROGRAM"
sections that follow to automatically scan and store active television channels into memory.
2. BASIC OPERATION PROCEDURE
1. Lowering the LCD Screen releases the AUTO POWER
SWITCH (see item #10 on page 9) and turns power on.
The input source last viewed will be automatically
selected.
If the screen is already lowered but power has been
turned off manually
(or by the AUTO POWER OFF
function)
, press the POWER button on the LSMD-121
Control Panel or remote control to turn power back on.
2. Press the TV/VIDEO button on the LSMD-121 Control
Panel or Remote Control to select the desired
mode.(TV, DVD, VIDEO 1, VIDEO 2)
3. If TV mode has been selected, select the desired channel using the CHANNEL /
but-
tons on the LSMD-121 Control Panel or Remote Control. Pressing the /
buttons
advances to the next lower or higher channel stored in memory.
Channels can be selected directly by using the 10-digit Keypad on the Remote Control.
Example: To select Channel 5, press "0" first, than press "5". (If "0" is not pressed first,
there will be a delay of about 5 seconds before the channel changes.)
4. If external speakers are connected to the EXTERNAL SPEAKERS OUTPUT CONNECTOR,
the VOLUME
-
/+ buttons on the Remote Control may be used to adjust the speaker's volume.
The volume level will be shown on the screen with a
bar scale and a reference number (0-100) as shown.
NOTE :
The volume level can be muted instantly by pressing the MUTE button on the
Remote Control. See "MUTE Button" on page 25.
Volume
33
(4)
(3)
(3)
(2)
(1)
(4)
Summary of Contents for LSMD-121
Page 27: ...DVD FUNCTION OPERATION 26 ...
Page 28: ...INTRODUCTION 27 ...
Page 29: ...INTRODUCTION 28 ...
